Powering On the Library
Powering On the Library
The library power switch is located on the upper right rear of the unit, as shown in
Figure 1–4, below. When the DLT Library is powered on or reset, it performs a
complete diagnostic routine and a tape audit. If the front door is opened and closed
while power is on, the library performs a tape audit only. During these operations,
the library displays its current activity on the display panel.
Figure 1–4.
Library Power Switch
CAUTION:
As part of the startup/reboot routine, the display briefly shows
software version numbers and the message "MENU available." Do
not press MENU at this time. The functions available here are for use
by qualified service personnel only. The routine will automatically
continue in a few seconds.
After the library completes its startup routine, the operator panel Status Display
shows current library and drive status information. To go to the Main Menu, press
the MENU button. Refer to Chapter 2, "Operating the Library," for detailed
information about the Status Display and library menus.
1–6
Hardware Operator's Guide
DLT Library