Saving The Output From A Display Command To A File - HP 6125XLG Configuration Manual

Characters
\W
\
For example:
# Use | begin user-interface in the display current-configuration command to match the first line of
output that contains user-interface to the last line of output.
<Sysname> display current-configuration | begin user-interface
user-interface aux 0
user-role network-operator
#
user-interface con 0
user-role network-admin
#
user-interface vty 0 15
authentication-mode scheme
user-role network-operator
#
ssh server enable
#
return
# Use | exclude Direct in the display ip routing-table command to filter out direct routes and display only
the non-direct routes.
<Sysname> display ip routing-table | exclude Direct
Destinations : 12
Destination/Mask
2.2.2.0/24
# Use | include snmp in the display current-configuration command to filter in entries that contain snmp.
<Sysname> display current-configuration | include snmp
snmp-agent
snmp-agent community write private
snmp-agent community read public
snmp-agent sys-info version all
snmp-agent target-host trap address udp-domain 192.168.1.26 params securityname public

Saving the output from a display command to a file

A display command shows certain configuration and operation information of the device. Its output
might vary over time or with user configuration or operation. You can save the output to a file for future
retrieval or troubleshooting.
Meaning
Same as [^A-Za-z0-9_], matches a
character that is not a digit, letter, or
underscore.
Escape character. If a special
character listed in this table follows
\, the specific meaning of the
character is removed.
Routes : 12
Proto Pre Cost
OSPF 10 2
Examples
"\Wa" matches "-a", but not "2a" or "ba".
"\\" matches a string containing "\", "\^"
matches a string containing "^", and "\\b"
matches a string containing "\b".
NextHop
1.1.2.2
12
Interface
XGE1/1/5