HP 6125XLG Configuration Manual page 35

Figure 9 Password authentication interface for Telnet login
Configuring scheme authentication for Telnet login
Step
1. Enter system view.
2. Enable Telnet server.
3. Enter one or multiple VTY
user interface views.
4. Enable scheme
authentication.
To use scheme authentication, you must also configure login authentication methods in ISP domain view.
For more information, see Security Configuration Guide.
The next time you attempt to Telnet to the CLI, you must provide the configured login username and
password, as shown in
attempt fails and the message "All user interfaces are used, please try later!" appears.
Command
system-view
telnet server enable
user-interface vty first-number
[ last-number ]
authentication-mode scheme
Figure 10. If the maximum number of login users has been reached, your login
28
Remarks
N/A
The defaults are as follows:
•
Telnet server is disabled if the device
started up with empty configuration.
•
Telnet server is enabled if the device
started up with the default configuration
file.
For more information about empty
configuration and the default configuration
file, see "Managing configuration
N/A
By default, password authentication is
enabled for VTY user interfaces.
files."