Configuration Example; Configuring The Port Priority - HP 6125G Configuration Manual

Step
2. Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view.
3. Configure the path cost of the
ports.

Configuration example

# In MSTP mode, specify the device to calculate the default path costs of its ports by using IEEE
802.1d-1998, and set the path cost of GigabitEthernet 1/0/3 to 200 on MSTI 2.
<Sysname> system-view
[Sysname] stp pathcost-standard dot1d-1998
[Sysname] interface gigabitethernet 1/0/3
[Sysname-GigabitEthernet1/0/3] stp instance 2 cost 200

Configuring the port priority

When the priority of a port changes, MSTP re-calculates the role of the port and initiates a state transition.
The priority of a port is an important factor in determining whether the port can be elected as the root
port of a device. If all other conditions are the same, the port with the highest priority will be elected as
the root port.
On a spanning tree device, a port can have different priorities and play different roles in different
spanning trees, so that data of different VLANs can be propagated along different physical paths,
implementing per-VLAN load balancing. You can set port priority values based on the actual networking
requirements.
To configure the priority of a port:
Step
1. Enter system view.
2. Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface
view.
3. Configure the port
priority.
Command
interface interface-type interface-number
•
In STP/RSTP mode:
stp cost cost
•
In MSTP mode:
stp [ instance instance-id ] cost cost
Command
system-view
interface interface-type interface-number
•
In STP/RSTP mode:
stp port priority priority
•
In MSTP mode:
stp [ instance instance-id ] port priority priority
75
Remarks
N/A
Use one of the commands.
By default, the system
automatically calculates the
path cost of each port.
Remarks
N/A
N/A
Use one of the
commands.
The default setting is
128.