Vlan Transparent Transmission Configuration Example - HP 6125G Configuration Manual

Configure GigabitEthernet 1/0/3:
# Configure GigabitEthernet 1/0/3 as a trunk port and assign it to VLAN 100.
[PE2] interface gigabitethernet 1/0/3
[PE2-GigabitEthernet1/0/3] port link-type trunk
[PE2-GigabitEthernet1/0/3] port trunk permit vlan 100
# Configure VLAN 100 as the PVID for the port.
[PE2-GigabitEthernet1/0/3] port trunk pvid vlan 100
# Enable basic QinQ on the port.
[PE2-GigabitEthernet1/0/3] qinq enable
[PE2-GigabitEthernet1/0/3] quit
On the third-party devices between PE 1 and PE 2, configure the port that connects to PE 1 and that
3.
connecting to PE 2 to allow tagged frames of VLAN 100 and VLAN 200 to pass through.

VLAN transparent transmission configuration example

Network requirements
As shown in
The two branches of a company, Site 1 and Site 2, are connected through the service provider
•
network and uses VLANs 10 through 50.
• PE 1 and PE 2 are edge devices on the service provider network and are connected through
third-party devices with a TPID value of 0x8200.
Configure the edge and third-party devices to allow frames of VLANs 10 through 50 to be transmitted
between the branches of the company via the service provider network with no outer VLAN tags added.
Figure 53 Network diagram
Configuration procedure
IMPORTANT:
Make sure that you have configured the switches in the service provider network to allow QinQ packets to
pass through.
Configure PE 1:
1.
Configure GigabitEthernet 1/0/1:
Figure 53:
165