Configuration Restrictions And Guidelines; Configuration Procedure; Configuring Destination Multicast Mac Address For Bpdus - HP 6125G Configuration Manual

Configuration restrictions and guidelines

Settings made in Layer 2 Ethernet interface view or Layer 2 aggregate interface view take effect
•
only on the current port.
Before you enable BPDU tunneling for DLDP, EOAM, GVRP, HGMP, LLDP, or STP on a port, disable
•
the protocol on the port first.
Because PVST is a special STP protocol, you must do two things before you enable BPDU tunneling
•
for PVST on a port: first, disable STP; second, enable BPDU tunneling for STP on the port.
• Do not enable BPDU tunneling for DLDP, EOAM, LACP, LLDP, PAGP, or UDLD on the member port
of a Layer 2 aggregation group.

Configuration procedure

You can enable BPDU tunneling for different protocols in different views.
Enabling BPDU tunneling for a protocol in Layer 2 Ethernet interface view
Step
1. Enter system view.
2. Enter Layer 2 Ethernet interface view.
3. Enable BPDU tunneling for a
protocol.
Enabling BPDU tunneling for a protocol in Layer 2 aggregate interface view
Step
1. Enter system view.
2. Enter Layer 2 aggregate interface
view.
3. Enable BPDU tunneling for a
protocol on the Layer 2 aggregate
interface.
Configuring destination multicast MAC address for
BPDUs
By default, the destination multicast MAC address for BPDUs is 0x010F-E200-0003. You can change it
to 0x0100-0CCD-CDD0, 0x0100-0CCD-CDD1, or 0x0100-0CCD-CDD2.
To configure destination multicast MAC address for BPDUs:
Command
system-view
interface interface-type
interface-number
bpdu-tunnel dot1q { cdp | dldp |
eoam | gvrp | hgmp | lacp | lldp |
pagp | pvst | stp | udld | vtp }
Command
system-view
interface bridge-aggregation
interface-number
bpdu-tunnel dot1q { cdp | gvrp | hgmp |
pvst | stp | vtp }
95
Remarks
N/A
N/A
Disabled by default.
Remarks
N/A
N/A
Disabled by default.