HP 6125G Configuration Manual page 123

Step
6. Enable dynamic
MAC-based VLAN
assignment.
7. Configure VLAN
matching precedence.
8. Disable the PVID of the
port from forwarding
packets with unknown
source MAC addresses
that do not match any
MAC address-to-VLAN
entry.
To configure dynamic MAC-based VLAN:
Step
1. Enter system view.
2. Enter Layer 2 Ethernet
interface view.
3. Configure the link type of the
ports as hybrid.
4. Configure the hybrid ports to
permit packets from specific
MAC-based VLANs to pass
through.
5. Enable the MAC-based VLAN
feature.
6. Configure 802.1X/MAC
authentication or any
combination.
Command
mac-vlan trigger enable
vlan precedence mac-vlan
port pvid disable
Command
system-view
interface interface-type
interface-number
port link-type hybrid
port hybrid vlan vlan-list
{ tagged | untagged }
mac-vlan enable
For more information, see
Security Command
Reference.
114
Remarks
By default, dynamic MAC-based
VLAN assignment is disabled.
When you use the mac-vlan trigger
enable command to enable dynamic
MAC-based VLAN assignment, HP
recommends that you configure the
vlan precedence mac-vlan command,
so that VLANs are assigned based on
single MAC addresses preferentially.
When dynamic MAC-based VLAN
assignment is enabled, HP does not
recommend configuring the vlan
precedence ip-subnet-vlan command,
which will make the system assign
VLANs based on IP subnets, because
the configuration does not take effect.
Optional.
By default, VLANs are preferentially
matched based on MAC addresses.
Optional.
By default, when a port receives a
packet with an unknown source MAC
address that does not match to any
MAC address-to-VLAN entry, it
forwards the packet in its PVID.
Remarks
N/A
N/A
By default, all ports are access ports.
By default, a hybrid port only permits the
packets of VLAN 1 to pass through.
Disabled by default.
N/A