Configuring The Customer-Side Port; Configuring The Network-Side Port - HP 6125G Configuration Manual

Step
1. Enter system view.
2. Create a class and enter class
view.
3. Configure CVLAN match
criteria.
4. Return to system view.
5. Create a traffic behavior and
enter traffic behavior view.
6. Add a VLAN nest action to
insert an outer VLAN tag into
the incoming packets from the
CVLAN or CVLANs.
7. Return to system view.
8. Create a QoS policy and
enter QoS policy view.
9. Associate the class with the
behavior.

Configuring the customer-side port

Step
1. Enter system view.
2. Enter Layer 2 Ethernet
interface view.
3. Configure the port as a hybrid
port.
Assign the port to the SVLANs
4.
as an untagged member.
5. Enable basic QinQ.
6. Apply the uplink policy to the
incoming traffic.

Configuring the network-side port

Step
1. Enter system view.
Command
system-view
traffic classifier tcl-name [ operator
or ]
if-match customer-vlan-id { vlan-list
| vlan-id1 to vlan-id2 }
quit
traffic behavior behavior-name
nest top-most vlan-id vlan-id
quit
qos policy policy-name
classifier tcl-name behavior
behavior-name
Command
system-view
interface interface-type
interface-number
port link-type hybrid
port hybrid vlan vlan-list untagged
qinq enable
qos apply policy policy-name
inbound
Command
system-view
182
Remarks
N/A
N/A
N/A
N/A
Repeat these steps to configure one
behavior for each SVLAN.
N/A
Repeat this step to create
class-behavior associations for
other CVLANs.
Remarks
N/A
N/A
The default link type of an Ethernet
port is access.
By default, a hybrid port is in only
VLAN 1.
By default, basic QinQ is disabled
on all ports.
N/A
Remarks
N/A