Table of Contents
Advertisement
Hardware Setup
Step 15.
CMOS Clearing (JP5)
After you have turned off your computer, clear the CMOS memory
by momentarily shorting pins 2-3 on jumper JP5, for a few seconds.
Then restore JP5 to the initial 1-2 jumper setting in order to recover
and retain the default settings.
CMOS Clearing
JP5 Setting
Note: You must unplug the ATX power cable from the ATX power
connector when performing the CMOS Clear operation.
Step 16. Set the Onboard Sound Options (JP9)
The onboard audio feature of your Motherboard is controlled by
jumper JP9.
Please refer to the following table:
Sound Settings
Onboard Sound: Enable
Onboard Sound: Disable
Step 17. MULTI I/O ADDRESSES
Default settings for multi-I/O addresses are as follows:
Port
LPT1
COM1
COM2
Warning: If a default I/O address conflicts with other I/O
cards such as sound card, you must change one of the I/O
addresses to remedy to this address conflict. (I/O addresses
can be adjusted from the BIOS Setup Utility)
Clear CMOS Data
Short pin 2-3
for a few
seconds to
clear the
CMOS
I/O Address
378H
3F8H
2F8H
SY-5SSM & SY-5SSM/5 V1.1
Retain CMOS Data
Short pin 1-
2 to retain
1
2
3
new
settings
short
IRQ
7
4
3
34
1
JP9
open
Status
ECP + EPP
2
3
Hide quick links:
Advertisement
Table of Contents
