Oki C911dn Troubleshooting Manual page 34

When a message related to replacement of consumables appears
Message displayed on the
Category
liquid crystal panel
Image Printing has been stopped
1
Drum because the lifespan of the
image drum has reached
Replace [COLOR] Image Drum
Please see HELP for details
Image Drum not properly
installed
Check Image Drum
Please see HELP for details
2
Waste Waste Toner Full
Toner Box Install New Waste Toner Box
Please see HELP for details
Fuser Unit Fuser Unit Life
Install New Fuser Unit
Please see HELP for details
Belt Unit Belt Unit Life
Install New Belt Unit
Please see HELP for details
- Caution, unknown consumable
detected
Go to User Manual "Trouble
Shooting" to restore operation
Error <ATTENTION>
code lamp
6800 Blinking The lifespan of the image drum
6801 has been reached.
6802 You cannot continue printing.
6803 Press the [HELP] button, and
6804 solve according to the guidance
6805 shown on the Help screen.
3400 Blinking Image drum shown in the
3401 message has not been set
3402 correctly.
3403 Press the [HELP] button, and
3404 solve according to the guidance
3405 shown on the Help screen.
357 Blinking Waste toner is full.
If you re-set and use a waste
toner box that is already used,
there is a risk of the waste toner
overflowing, so please replace it
with a new waste toner box.
Press the [HELP] button, and
solve according to the guidance
shown on the Help screen.
354 Blinking Lifespan of the fuser unit has
reached
Press the [HELP] button, and
solve according to the guidance
shown on the Help screen.
355 Blinking Lifespan of the belt unit and
the transfer roller unit has been
reached.
Press the [HELP] button, and
solve according to the guidance
shown on the Help screen.
709 Blinking You can use any consumables
in your product, but you must
accept the risks of using non-
genuine consumables. If the use
of non-genuine consumables
causes damage to the product
or results in your product
not functioning to its full
specification, then such damage
or effect on the product is not
covered by warranty. To accept
these risks and to restore
function;
1. Turn off your product.
2. Press and hold the [CANCEL]
button and turn your product
on.
3. After start up, release the
[CANCEL] button.
Note
This operation will be recorded
for future reference.
- 34 -
Causes and
Troubleshooting
Reference
pages
page 57
-
page 67
page 65
page 60
-