Lexmark C935 - Lexmark MS610dn Manual

Printer specifications
Card stock Width:
Length:
Weight:
Card stock and label guidelines
When printing on labels:
•
From the printer control panel, set Paper Type to Labels in the Paper Menu.
•
Do not use label sheets with a slick backing material.
• Do not print within 1 mm (0.04 in.) of the die‑cut, the edge of the label or the perforations, or between the die‑cuts.
• Use full label sheets. Partial sheets may cause labels to peel off during printing, resulting in a paper jam.
•
Do not use label sheets that have adhesive to the edge of the sheet. We recommend zone coating of the adhesive
at least 1 mm (0.04 in.) away from the edges. Adhesive material may contaminate your printer and could void your
warranty.
When printing on card stock:
• From the printer control panel, set Paper Type to Card Stock.
•
Do not use creased card stock. It may cause paper jams.
•
We recommend the use of grain long card stock.

Lexmark C935

Limit label printing to occasional use of A4‑ or letter‑size paper office labels designed for laser printers. We do not
recommend using vinyl or polyester labels.
Lexmark C935 supports card stock up to 220 g/m
The following table lists the maximum weights supported by the trays and the multipurpose feeder.
Labels
Card stock
210–216 mm (8.3–8.5 in.)
279–356 mm (11–11.7 in.)
Up to 216 g/m
2
.
Tray 1
Not applicable
2
105 g/m
2
Trays 2 and 3
Not applicable
2
220 g/m
Multipurpose feeder
2
220 g/m
2
220 g/m
60