Lexmark W840 - Lexmark MS610dn Manual

Printer specifications
•
Use full label sheets. Partial sheets may cause labels to peel off during printing, resulting in a paper jam.
• Do not use label sheets that have adhesive to the edge of the sheet. We recommend zone coating of the adhesive
at least 1 mm (0.04 in.) away from the edges. Adhesive material may contaminate your printer and could void your
warranty.
When printing on card stock:
•
Set the Paper Type to Card Stock.
• Do not use card stock that is creased. It may cause paper jams.
•
We recommend the use of grain long card stock.

Lexmark W840

Limit label printing to occasional use of A4‑ or letter‑size paper office labels designed for laser printers. We do not
recommend using vinyl or polyester labels.
The Lexmark W840 supports stocks up to 216 g/m
feeder.
The following table lists the maximum weights supported by the trays and the multipurpose feeder.
Labels
Card stock
Labels Width:
Length:
Weight:
Thickness:
Smoothness:
* 150–250 Sheffield is optimal. Using media higher than 300 Sheffield could result in printing degradation.
Card stock Width:
Length:
Weight:
2
. Always feed labels and card stock from Tray 1, 2, or the multipurpose
Tray 1
2
64–105 g/m
2
64–105 g/m
89–297 mm (3.5–11.7 in.)
99–432 mm (3.9–17 in.)
64–216 g/m
Up to 0.25 mm
100–400 Sheffield*
89–297 mm (3.5–11.7 in.)
99–432 mm (3.9–17 in.)
Up to 216 g/m
Tray 2
2
64–216 g/m
2
64–216 g/m
2
2
Multipurpose feeder
2
64–216 g/m
2
64–216 g/m
104