Activating Backlighting (Optional); Troubleshooting - Universal Electronics OCAP 5 User Manual

Enter 9 8 0. The last-selected device key
2.
blinks twice, pauses, and blinks twice again to
confirm that all custom programming is
cleared.

ACTIVATING BACKLIGHTING (OPTIONAL)

On some models of your Atlas OCAP 5-Device Remote
Control with Learning, you can activate backlighting.
Backlighting enables your remote's keypad to remain lit
for five seconds after you press any key. To enable
backlighting on a remote with that feature, perform the
following step:
1. Press SETUP twice within one second.
Backlighting is turned on.
To disable backlighting, perform the following step:
Press SETUP twice within one second.
1.
Backlighting is turned off.

TROUBLESHOOTING

PROBLEM: Device key does not blink when you press a
key.
SOLUTION: Replace the batteries with two (2) new AA
batteries (see "Installing Batteries" on page 9).
PROBLEM: Device key blinks when you press a key, but
home entertainment device does not respond.
SOLUTION: Make sure you are aiming the remote control
at your home entertainment device and that you are
within 15 feet of the device you are trying to control.
PROBLEM: The remote control does not control home
entertainment devices or commands are not performing
properly.
SOLUTION: Try all listed codes for the device brand
being set up. Make sure all devices can be operated with
an infrared remote control.
PROBLEM: TV/VCR Combo does not respond properly.
SOLUTION: Use the VCR codes for your brand. Some
combo units may require both a TV code and a VCR
code for full operation (see page 11).
PROBLEM: No volume on a second TV.
SOLUTION: Follow instructions under "Changing
Volume Lock" on page 18.
www.urcsupport.com/atlasocap
25