Completing The Parts Replacement - Lenovo 10AQ Maintenance Manual

• To complete the installation or replacement, go to "Completing the parts replacement" on page 122.
Removing the front Wi-Fi antenna
To remove the front Wi-Fi antenna, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See "Removing the computer cover" on page 85.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 86.
4. Disconnect the front antenna cable from the Wi-Fi card module.
5. Remove the front antenna and cable from the front of the computer.
Figure 57. Removing the front Wi-Fi antenna
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 122.

Completing the parts replacement

After completing the installation or replacement for all parts, you need to reinstall the computer cover and
reconnect cables. Depending on the parts you installed or replaced, you might need to confirm the updated
information in the Setup Utility program. Refer to Chapter 6 "Using the Setup Utility program" on page 55.
To reinstall the computer cover and reconnect cables to your computer, do the following:
1. Make sure that all components have been reassembled correctly and that no tools or loose screws
are left inside your computer. See "Locating major FRUs and CRUs" on page 70 for the locations of
various components in your computer.
122
ThinkCentre E93 Hardware Maintenance Manual