Replacing The Heat Sink And Fan Assembly - Lenovo 10AQ Maintenance Manual

6. Install the new system fan by aligning the new rubber mounts with the corresponding holes in the
chassis and push the rubber mounts through the holes.
7. Pull on the tips of the rubber mounts until the new system fan is secured in place.
Figure 28. Installing the system fan
8. Connect the new system fan cable to the system fan connector on the system board. See "Locating
parts on the system board" on page 73.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 122.

Replacing the heat sink and fan assembly

CAUTION:
The heat sink and fan assembly might be very hot. Turn off the computer and wait three to five
minutes to let the computer cool before removing the computer cover.
Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
in the Safety, Warranty, and Setup Guide that came with your computer. To obtain a copy of the Safety, Warranty, and
Setup Guide, go to:
http://www.lenovo.com/support
This section provides instructions on how to replace the heat sink and fan assembly.
.
Chapter 9 Replacing FRUs (machine type: 10AR)
99