Installing The Pedal Sensor; Connecting The Connector - JUKI DDL-8700B-7 Instruction Manual

2. Installing the pedal sensor

❶

3. Connecting the connector

WARNING :
• To protect against personal injury resulting from abrupt start of the sewing machine, be sure to turn
the power OFF, unplug the machine and wait for five minutes or more before installing the pedal
sensor.
• To prevent damage of device caused by maloperation and wrong specifications, be sure to connect
all the corresponding connectors to the specified places. (If any of the connectors is inserted into a
wrong connector, not only the device corresponding to the connector can break but also it can start
abruptly, inviting the risk of personal injury.)
• To prevent personal injury caused by maloperation, be sure to lock the connector with lock.
• As for the details of handling respective devices, read carefully the Instruction Manuals supplied
with the devices before handling the devices.
Machine head
connector
AC power supply
Pedal
Connector connection diagram
Underside of the table
Pedal sensor
Pedal sensor cable
❷
❶
❸
Cable draw-out hole
Slack
Staples
AC input cable
Staples
1) Install the pedal sensor to the table with mounting
screws ❶ supplied with the unit.
It is necessary to install the pedal sensor at such
a position that the connecting rod is perpendicu-
lar to the table.
2) After the completion of installation of the pedal
sensor on the table, place the sewing machine
head on the table.
Do not insert the power plug into the wall
outlet.
Check to be sure that the power switch is
turned OFF.
1) Connect pedal sensor cable ❶ and AC input
cable ❷ supplied with the machine to the control
box. For the connection ports of the cables, refer
to the connector layout drawing.
Be sure to fully insert the connectors into
the corresponding ports until they are
locked.
2) Draw out cable of the control box through cable
draw-out hole ❸ to route it to the underside of
the sewing machine table.
3) Fix the pedal cable and AC input cable
with a staple.
– 4 –