One-Touch Setting - JUKI DDL-8700B-7 Instruction Manual

5. One-touch setting

A part of function setting items can be easily changed in the normal sewing state.
❾ 
[Setting items]
SPd ( )
When function setting No. 20 is set at "0": nip (
When function setting No. 20 is set at "1" : Wip (
TrM ( )
n. ( )
[Setting procedure (example: Wip)]
1. In the case the function setting (n.) is selected, operation using
carried out. Once the setting of the function setting is finished, turn the power "ON", then
"OFF" and "ON" again.
2. Once the power switch is turned off, be sure to wait for ten seconds or more before turning
it on again. If the power is re-turned on immediately after it has been turned off, the sewing
machine may not operate normally. In such a case, turn the power on again correctly.

)
)
switches ❾ to select the setting item. (Example: niP)
1) Press and
switch . The current set value is displayed. (Example: on)
2) Press
switches ❾ to change the set value. (Example: oFF)
3) Press and
switch  to confirm the set value.
4) Press
switch  to finish the one-touch setting.
5) Press
– 23 –
switch  held pressed (for two seconds
Keep
or more) to carry out setting.
* If the indication shown on the screen does not
change, keep the switch held pressed again.
Sewing speed
Thread clamp (wiper) operation : ON/OFF
Thread trimming operation after one-shot automatic stitch-
ing: ON/OFF
Function setting
switch  cannot be