Adjusting The Height Of The Knee Lifter; Installing The Thread Stand - JUKI DDL-8700B-7 Instruction Manual

7. Adjusting the height of the knee lifter

WARNING :
Be sure to turn the power OFF before the following work in order to prevent personal injury due to
unintentional starting of the sewing machine.
❸

8. Installing the thread stand

❶
❶
❷
– 7 –
1) The standard height of the presser foot lifted
using the knee lifter is 10 mm.
2) You can adjust the presser foot lift up to 13 mm
using knee lifter adjust screw ❶.
3) When you have adjusted the presser foot lift
to over 10 mm, be sure that the bottom end of
needle bar ❷ in its lowest position does not hit
presser foot ❸.
1) Assemble the thread stand unit, and insert it in
the hole in the machine table.
2) Tighten nut ❶.