Parking Brake Reminder Light; Service Reminder Light (Srl); Shift Indicator Light (Manual Transmission Only); Programming Instructions For Shift Indicator - Volvo 760 Owner's Manual

1987 Volvo 760
brake pedal. The on/off switching of the trunk-mounted ABS modulator may also be audible. This is
normal. Please be aware that ABS does not increase the absolute braking potential of the vehicle. Thus,
while control will be enhanced, ABS will not shorten stopping distances on slippery surfaces.

Parking brake reminder light

This light will be on when the parking brake (hand brake) is applied. The parking brake lever is situated
between the front seats.
pg. 12 Instruments

Service Reminder Light (SRL)

This light will come on at 5000 mile (8000 km) intervals. It is a reminder to the driver to have the engine
oil changed. The light will stay on 2 minutes after start until reset by the servicing dealer.

Shift indicator light (Manual transmission only)

The Volvo shift indicator light (S.I.L.) is a device designed to help you get even better gas mileage from
your Volvo car. Studies have shown that the best fuel economy is obtained by shifting gears at low
engine rpm and high relative engine load. The Volvo S.I.L. is calibrated to show you when to shift for
improved mileage without sacrificing smooth acceleration.
Use of the S.I.L. is simple. Shift to the next higher gear as soon as the light comes on. You may find
after using the S.I.L. for some time that your natural shifting rhythm will adapt to the S.I.L's suggestion.
Some drivers may even shift before the light comes on.

Programming instructions for shift indicator

If the current supply to the control unit is cut (battery disconnected), the control unit will have to be re-
programmed as the control unit memory will be erased.
Drive the car in each gear (first gear not necessary) for approximately 8 seconds. The gear change
indicator light with flicker on(0.5 seconds), as each gear is programmed.
Note: Remove foot completely from the clutch pedal after each gear change when programming the
control unit.
file:///K|/ownersdocs/1987/1987_760/87760_01.htm (7 of 21)12/30/2006 7:55:28 AM