Points To Remember; Cooling System; Electrical System - Volvo 760 Owner's Manual

1987 Volvo 760
The following "Special Tips" apply to cars with automatic transmission
For steep hills and when driving for prolonged periods at low speeds, position 1 should be selected.
Avoid, however, repeated changes since this can cause overheating of the transmission oil. For driving
on long, continuous uphill gradients, select position 2.
Select position 1 when descending long, steep downgrades and position 2 for less-steep downgrades,
in order to obtain the best possible engine braking effect.
Do not hold the car stationary on an incline by using the accelerator pedal. Instead, apply the hand
brake (parking brake). This prevents the transmission oil from becoming overheated.
When towing a trailer, disengage 4th gear (the indicator light on the instrument panel illuminates).
pg. 53 Points to remember

Cooling system

The risk for overheating is greatest, especially in hot weather, when:
towing a trailer up steep inclines for prolonged periods at full throttle and low engine rpm.
idling for prolonged periods while the air conditioning system is in operation.
stopping the engine suddenly after high speed driving (so-called "after-boiling" can occur). To avoid
overheating, the following rules should be followed:
Reduce speed and downshift when towing a trailer up long, steep inclines. The risk of overheating can
be reduced by switching off the air conditioning system for a short time.
Do not let the engine idle unnecessarily for prolonged periods.
Do not stop the engine immediately after high-speed driving, but instead, allow the engine to idle for
1/2-1 minute before switching off.
Do not mount auxiliary lamps in front of the grill.
When the risk of overheating is imminent, or in the event of overheating, (the temperature gauge goes
repeatedly into, or stays continually in, the red section) the following precautions should be taken:
Switch off the air conditioning system.
Stop the car and put the gear lever into neutral (position N). Do not stop the engine!
Increase the engine speed to approx. 2000 rpm (twice idling speed).
Check the level of coolant in the expansion tank. Top-up, if necessary. See "Cooling System".

Electrical system

When replacing the battery or when carrying out work involving the electrical system, the following
should be observed:
A battery connection to the wrong terminal will damage the diodes. Before connections are made,
check the polarity of the battery with a voltmeter.
If booster batteries are used for starting, they must be properly connected to minimize the risk of the
diodes' being damaged. For correct connection, see "Jump starting" section.
Never disconnect the battery circuit (for example, to replace the battery) while the engine is running,
as this will immediately ruin the alternator. Always make sure that all the battery connections are
file:///K|/ownersdocs/1987/1987_760/87760_03.htm (11 of 21)12/30/2006 7:55:32 AM