Slide Rail Replacement; Flood Sensor Removal - Fisher & Paykel DishDrawer DD603 Service Manual

March 2004
9.16

Slide Rail Replacement

9.16.1 Remove the Tub as per instructions in 9.2.
9.16.2 Remove the lid actuator from the slide rail as per instructions in
9.15.
9.16.3 Bottom slide rails only. The lower plastic chassis trim must be
removed as per instructions in 9.22 to gain access to the screws
securing the front of the slide rail. Remove the two hex drive screws
securing the slide runner at the front.
9.16.4 Tap the slide rails from underneath at the front.
This will knock the slide rail up and free from its location in the
chassis.
9.16.5 The slide runner may now be pulled forward to release it from its
location in the rear of the chassis.
9.16.6 Refit in reverse manner.
9.17 Chassis Circuit Board / Flood Sensor Removal
9.17.1 Remove lower tub as per instructions in 9.2.
9.17.2 Release clip on chassis module cover and slide cover to the
right to remove.
9.17.3 Disconnect all wiring to the chassis circuit board taking care
not to damage the small lid actuator motor plugs.
9.17.4 Remove centre earth screw from chassis circuit board.
9.17.5 Release the clip holding the left-hand end of the circuit board
down.
9.17.6 Carefully lift the left-hand end of the circuit board up and then
to the left taking care not to damage the flood sensor.
9.17.7 Refit in reverse manner
- 44 -
Manual 599082