Fast Test Cycle; Continuous Cycle Test Mode - Fisher & Paykel DishDrawer DD603 Service Manual

March 2004
Press Power to Exit at any time (All outputs will be switched off on exit).
As mentioned above the LCD display and touch switch panel LED's are illuminated to correspond to a particular
hardware device. The following table details the display order of the test.
LCD Norm Fast
-------------------------------------------------------------------------------------------
bL Off Off
Er Off Off
Ld Off Off
dd Off On
FU Off On
P1 Off On
P2 Off On
rd On Off
dF On Off
LE On Off
C1 On Off
C2 On On
°C On On
°E On On
(C3 is used in the Factory to empty the Water Softener before the Product is packed.)
WARNING : In diagnostic mode there is no component protection. Therefore take care when running individual
components not to overload them. It is advisable to avoid turning the element on without filling the tub with water
first.
NB : No Fault codes will come up while in diagnostics mode.
Tub Home Sensor Test: At any time during HO test mode the Keylock symbol on the LCD display (Keylock LED
on integrated badge) indicates the tub position. On = Closed, Off = Open.
5.1.5

Fast Test Cycle

WARNING : only run this cycle if connected to the water supply
This level runs a 5 minute fast test cycle.
Press Power to skip Fast Test Cycle and advance to the next level.
Press Start/Pause to enter Fast Test cycle.
Once Fast Test Cycle is selected the DishDrawer goes into standby mode and 5 minutes will be showing on the
display. The test cycle is started by pushing Start/Pause and the following components are run during the 5 minute
cycle that follows:- Lid motors, fill valve, wash motor, element, drain motor.
Press Power to Exit at any time.
5.1.6

Continuous Cycle Test Mode

In this level the DishDrawer can be run continuously in any wash cycle. Once the cycle has finished, the DishDrawer
automatically restarts the same wash cycle.
Press Power to skip Continuous Cycle. As this is the last level, doing this will exit diagnostics.
Deli Rinse
Off On
On Off
On On
Off Off
Off On
On Off
On On
Off Off
Off On
On Off
On On
Off Off
Off On
On Off
Hardware Output
Backlight
Element Relay
Lid Motors
(will run for 10 seconds)
Detergent Diverter Valve
Fill Water Valve
Motor Wash direction
(2300-2850 rpm)
Motor Drain direction
(4200 rpm)
Rinse Aid Dispenser
(dispenses
current setting)
Drying fan
Rinse Aid LED
Water Softener Diverter Valve
Water Softener Brine Pump
Displays current water
temperature.
Displays controller rail voltage
- 21 -
Manual 599082