Table of Contents
Advertisement
6.15
Slide Runner Replacement
6.15.1 Remove the Tub as per instructions 6.11
6.15.2 Bottom slide runners only. Remove the two large Philips head screws securing
the slide runner at the front. The backing plate that the screws locate into may
come loose. This does not matter. It can be realigned on reassembly.
6.15.3 Tap the slide runner from underneath at the front. This will knock the slide runner
up and free from its location in the chassis.
Note: On the bottom lefthand slide runner the water valve mounting bracket will
come away as well. This will mean the water and electrical connections will have
to be disconnected first. On the top LHS slide runner the tub home microswitch
will have to be disconnected.
6.15.4 The slide runner may now be pulled forward to release it from its location in the
rear of the chassis.
6.15.5 Refit in reverse manner.
6.16
Front Trim Replacement
6.16.1 The trim has to be removed by breaking the retaining clips.
6.16.2 This can be done by slipping a blade screwdriver between the trim and the
chassis and twisting the blade to snap the clips. Protect the cabinet from chipping
and remove the broken clips.
6.16.3 Line up the clips on the replacement trim with the holes in the chassis and push
home.
6.17
Sound Gasket Replacement
6.17.1 Remove the sound gasket by grasping it in the middle with your fingers and pulling
it out of the trim.
6.17.2 To refit, feed the ends of the sound gasket into the ends of the trim slot.
6.17.3 Push the middle section of the sound gasket into the slot then work the rest in.
6.17.4 Roll the sound gasket with a coin to get it even.
- 44 -
Advertisement
Table of Contents
