Water Valve Removal - Fisher & Paykel DishDrawer DD603 Service Manual

March 2004
9.18

Water Valve Removal

9.18.1 Remove the lower tub as per instructions in 9.2.
9.18.2 Remove the chassis module cover as per instructions in 9.17.
9.18.3 Disconnect the wiring connections to both solenoid coils. Release
the locking tabs for the connectors with a blade screwdriver while
doing this.
9.18.4 Disconnect the inlet hose connection.
9.18.5 You can now slide the water valve up out of its mounting bracket.
9.18.6 Disconnect the two fill hoses off the valve noting which hose goes to
the top and tub and which goes to the bottom tub.
9.18.7 Refit in reverse manner.
9.19 Fill Hose, Drain Hose, Wiring Harness Replacement
9.19.1 Remove wiring cover as per instructions in 9.9.
9.19.2 Remove tub as per instructions in 9.2.
9.19.3 From the tub end disconnect the component you need to replace
(fill hose, drain hose, wiring harness).
9.19.4 Remove the relevant component from each of the three link clips
and the chassis clips holding it.
Do this one at a time marking its position at each clip in the link
and closing each clip after the component is removed to keep
the other two components clipped in the correct position.
9.19.5 The component can now be disconnected from the chassis end
and removed.
9.19.6 Refit in the reverse manner ensuring the link clips are clamping
the components in their correct location.
- 45 -
Manual 599082