Drying Fan Removal; Isplay Removal - Fisher & Paykel DishDrawer DD603 Service Manual

March 2004
9.3 Drawer and LCD Display Removal
9.3.1 Remove the drawer front as per instructions in 9.1.
9.3.2 The handle fits onto a lip at the top of the tub and then
slides from left to right to lock into place. Push the
right-hand end of the handle to the left until it feels free
then remove it out towards you.
9.3.3 Disconnect the six wire harness from the electronic
controller to the LCD interface.
9.3.4 The handle may now be lifted clear.
The LCD display is held in place by a spring tab on one
end and a clip in the centre. Use a small blade
screwdriver to carefully release the tab and centre clip
as shown. The LCD assembly can now be removed.
9.3.5 The wiring harness can now be unplugged from the
LCD.
9.3.6 Refit in reverse manner.
9.4

Drying Fan Removal

9.4.1 Remove the drawer front as per instructions in 9.1.
9.4.2 With a small bladed screwdriver carefully release the
small plastic clips holding the rinse aid indication LED
in place and remove the LED.
9.4.3 Slide forward the drying fan duct and remove.
9.4.4 Disconnect the four wire harness from the electronic
controller
9.4.5 Release the three securing tabs that hold the drying
fan in place while applying forward pressure on the
drying fan.
9.4.6 The drying fan will now come free.
9.4.7 Refit in reverse manner.
- 37 -
Manual 599082