Table of Contents
Advertisement
INSTALLER CHECKLIST
TO BE COMPLETED BY THE INSTALLER
Installation
…
Check all parts are installed correctly and are secure.
…
Ensure all packaging, tape and rubberbands have been removed.
…
Ensure all clearance gaps have been maintained.
…
Ensure dishwasher is securely fastened to the cabinetry and door opens and closes
freely with no resistance.
…
Ensure panel is fitted correctly to the dishwasher
…
Check the spray arm is in place, mounted correctly and rotates freely.
Plumbing
…
Ensure all plumbing has been conducted in accordance with local regulation.
…
Ensure any knock-outs or plugs in drain connection have been drilled out and drain
connection has been made.
…
The drain hose joiner must not support the weight of excess hose material. Keep drain
hose as fully extended as possible to prevent sagging. Any excess length of drain hose
should be kept on the dishwasher side of the drain hose support.
…
Ensure inlet hose has supplied rubber washer fitted, and that it is tightened.
…
If connecting the drain hose to the sink trap, ensure the highloop is a minimum 150mm
higher than the drain hose joiner.
…
Ensure water supply is turned off until power is connected and turned on. The
dishwasher must be powered on for the flood protection feature to be enabled.
…
Check for leaks.
Electrical
…
Ensure all electrical tests have been conducted in accordance with local regulations.
…
Ensure metal toe kick plate has been re-fitted.
…
If site is left without power after installation is complete, ensure water supply is
turned off to prevent flooding.
16
TEST OPERATION
1
2
3
DW24UNT4X2 model shown. Refer to your User Guide for more information on your models functions.
Turn power and water supply on and
open the dishwasher.
Select
.
RINSE
After the
cycle has finished,
RINSE
ensure the dishwasher has run and
drained correctly. Check for any leaks.
Advertisement
Table of Contents
