2.15.2
Basic setting with the control panel V810 or V820
2
Caution: Danger of injury !
Adjust the potentiometer only with the main switch switched off.
Work with utmost caution.
–
Loosen the stop screw 1 for the potentiometer 2.
–
Keep the key "P" pressed and switch on the main switch.
–
Enter the technician level.
–
Select the parameter "F-188".
–
Actuate the key "E".
The current Speedomat grade (e.g. 11) and the corresponding
driving speed limitation (e.g. 2860) are displayed.
–
Turn the potentiometer shaft until the Speedomat grade "07" and
the corresponding maximum driving speed of 3800 rpm resp. 3400
rpm (depending on the subclass) are indicated on the display.
–
Tighten the stop screw 1.
–
Check the setting.
1
GB
47