Dürkopp Adler 867 Service Instructions Manual page 15

11
–
Turn the stitch regulator handwheel to position "0".
–
Set the gear to "0".
In order to do so turn the positioning frame14 so that the tongues
come parallel to each other
–
Tighten the screw 13 on the block 12.
–
Align the feed dog in longitudinal direction in the center of the
throat plate cutout.
–
Tighten the screw 5 (see picture on page 12).
–
Fit in the spring 1 (see picture on page 12) on the positioning frame
and the fastening bracket.
ATTENTION: Danger of breakage !
The shaft 11 must not reach so far into the positioning frame 14
that the tongues are hindered in their movements.
12 13
GB
13