Removing The Main Unit - Clarion NX501 Owner's Manual & Installation Manual

Installing the Main Unit in TOYOTA Vehicle
Install by using parts attached to the vehicle. (Screws marked
Center Panel
* 2
( )
*2. Some panel openings are too small for the unit
depending on the vehicle type and model. In such
a case, trim the upper and lower sides of the panel
frame by about 0.5 to 1.5 mm so the unit can be
inserted smoothly.
E x
Vehicles other than NISSAN and TOYOTA
In some cases the center panel may require modification. (Trimming, filing, etc.)

• Removing the Main Unit

When the main unit is to be removed, disassemble it in the reverse of the order in
"INSTALLING THE MAIN UNIT".
62 NX501/NZ501
Main Unit
Figure 7
Figure 7
Typical Mounting Brackets
a m p e l 1 Example 2
Affix the screws to the
are attached to the vehicle.)
* 3
*3. If a hook on the installation bracket interferes with
the unit, bend and flatten it with a nipper or similar
tool.
E
marks.
8- Hexagonal screws
8-Hexagonal screw
(M5x8)
(M5 8)
Mounting bracket
Mounting bracket
(1 pair for the left and (1 pair for the left
right sides) and right sides)
x a m p e l 3