Table of Contents
Advertisement
Removing The Main Unit
① When the rear of the main unit has been secured through the method as shown in the following
figure, unfasten the special screw.
② Insert the hook plate into the universal mounting bracket, then pull the main unit out by the hook
plate. (Insert both the right and left edges of the hook plate.)
Unversal mounting bracket
2-Hook Plate
Keep the hook plate. You cannot remove the main unit without disengaging the hook plate.
※
Cautions On Wiring
Be sure to turn the power off before wiring. Be particularly careful where you route the wires.
Keep them well away from the engine, and exhaust pipe, etc. Heat may damage the wires.
If the fuse should blow, check to see if the wiring is correct. If it is, replace the fuse with a new one
with the same amperage rating as the original. To replace the fuse, remove the old fuse of the
power supply lead and insert the new One.
There are various types of fuse holder. Do not let the battery side touch other metal parts.
※
After the connection, fix the lead by a clamp or insulation tape for protection.
※
Fuse holder
Instrument panel
Fuse
Advertisement
Table of Contents
