Cylinder Speed; Position Of The Rest Plate - DURKOPP ADLER 745-34 Speedpocket User Manual

1

11.4 Cylinder speed

11.5 Position of the rest plate

80
The speed can be set with the throttling valves at the cylinders 1 and 2.
Adjust the end cushioning 7 at the cylinder 2 in such a way that the
lever reaches the end position rapidly, but not abruptly.
6
5
The height of the bow 3 with rest table 4 can be adjusted so that
workpieces of different length and bundles of different thickness can
be stacked.
–
Loosen the clamping lever 5 and adjust the position.
–
Tighten the clamping lever 5.
By swivelling the rest table 4 the deposit surface can be adjusted
(short and long workpieces).
When the position has been found, the locking lever 6 can be inserted
in the corresponding hole in the rest table.
7 2 7
3
4