DURKOPP ADLER 745-34 Speedpocket User Manual page 11

9
2
8
Removing the machine head
–
Remove the covering cap 1.
For this purpose lift the covering cap at the front and at the back so
that the arrest is released. Lift the covering cap carefully.
–
Swivel the folding station 3 out by 90°.
–
Swing the locking lever 4 upwards.
–
Lift the fabric sliding sheet 6 at the front and swing it to the left.
–
Pull off plug 7 from the circuit board.
–
Pull off the main pneumatic hose 11 from the solenoid valve
block 10.
–
Loosen the gas shock absorber connection 2.
–
Unscrew screws 8 and 9.
–
Pull off the plug from the motor at the control cabinet and
disconnect the plug connection from the proximity switch.
–
Lift out the machine head carefully with an appropriate auxiliary
tool.
Installing the machine head
–
Carefully insert the machine head into the cutout for the head with
an appropriate auxiliary tool.
–
Screw the machine head tight with the screws 8 and 9.
–
Re-establish the gas shock absorber connection 2.
–
Connect the pneumatic hose 11 to the solenoid valve block 10.
–
Put plug 7 on the circuit board again.
–
Insert the fabric sliding sheet.
–
Swing the locking lever 4 downwards.
–
Swing the folding station 3 back and let it catch.
–
Put on the covering cap 1 and let it snap in.
7 11 10
9