Denon DVD-3910 Operating Instructions Manual page 80

ENGLISH
Symptom
An image is not projected with an
HDMI/DVI connection.
Remote control unit does not operate.
80
• Check the HDMI/DVI connection.(Check the status of the HDMI/DVI-related indicators.)
• Check whether the connected monitor equipment or other equipment supports HDCP.
(The DVD-3910 will not output a video signal unless the other equipment supports
HDCP.)
• Check the settings of "HDMI/DVI SELECT".
• Check whether the output format of the DVD-3910 (HDMI/DVI FORMAT) matches the
supported input format of other connected equipment.
• Check whether the video output setting at "PURE DIRECT" is set to "VIDEO OUT:OFF"
or "ALL OFF".
• Check that the batteries are inserted in the proper "<" and ">" directions.
• The batteries are dead. Replace them with new batteries.
• Point the remote control unit at the remote control sensor when operating it.
• Operate the remote control unit within a distance of 7 meters from the remote control
sensor.
• Remove the obstacle between the remote control unit and remote control sensor.
Check Page
19, 20
19, 20
53
19, 20
47, 48
23
23
23
23
23