Denon DVD-3910 Operating Instructions Manual page 15

(5) Connecting to a Digital Recorder (MD Recorder, DAT Deck, etc.)
✽ Set the "AUDIO SETUP" default setting as shown below. (See pages 38 ~ 41.)
• "DIGITAL OUT" → "PCM"
"LPCM (44.1kHz/48kHz)" → "ON"
Playing DVDs with incorrect settings may result noise that could damage your ears or the speakers.
DVD-3910
NOTE:
• Digital audio signals cannot be output when playing Super Audio CDs. Use analog connection to record Super Audio CDs.
(6) Connecting to a Stereo Component
DVD-3910
NOTE:
• When connecting to a 2-channel audio stereo device using the 5.1ch AUDIO OUT, set "AUDIO CHANNEL" under "AUDIO SETUP"
on the "SETUP" to "2CH (SRS OFF) " or "2CH (SRS ON) " (See page 38.). For multi-channel sources, the signals are down-mixed
into two channels (analog).
(Only the front left and right channels are output for sources for which down-mixing is prohibited.)
Optical fiber cable (commercially available)
(or)
75Ω/ohms pin-plug cable (commercially available)
B
Digital audio Digital audio
input connector input connector
(OPTICAL) (COAXIAL)
Stereo component
ENGLISH
8 9
15