Installing And Removing The Paper Roll; Recording Paper Specifications; Installing The Receipt Paper Roll - Sharp ER-A280F Instruction Manual

Installing and Removing the Paper Roll

I Recording paper specifications
Be sure to use paper rolls specified by SHARP.
The use of any other paper rolls than specified could cause paper jamming, resulting in register malfunction.
Paper specification
Paper width:
Max. outside diameter: 80 mm
Quality:
Paper tube:
• Be sure to set a paper roll prior to using your machine, otherwise it may cause a malfunction.
Install the paper roll in the printer. Be careful then to set the roll and cut the paper end correctly.
If the top end of the paper roll is fixed with paste or tape, the paper may lose its color
NOTE
development ability in the pasted or taped area due to the deterioration of the heat-sensitive
color development component of the paper surface. This may result in nothing appearing at this
location when printing is performed. Therefore, when setting a new paper roll in the machine, be
sure to cut off approximately one revolution (approx. 25 cm long).
(How to set the paper roll)
To the printer
Incorrect
I Installing the receipt paper roll
Precaution: The paper cutter is mounted on the printer cover. Be careful not to cut yourself.
57.5 ± 0.5 mm
Thermal paper
18 mm
To the printer
Correct
1.
Remove the printer cover.
2.
Push down the print roller release lever to open the print
roller arm.
(How to cut the paper end)
Correct Incorrect
175