Installing And Removing The Paper Roll; Recording Paper Specifications; Installing The Paper Roll - Sharp ER-A440 Instruction Manual

4

Installing and removing the paper roll

Recording paper specifications

Be sure to use paper rolls specified by SHARP.
The use of any other paper rolls than specified could cause paper jamming, resulting in register malfunction.
Paper specification
Paper width:
Max. outside diameter: 80 mm
Weight:
Quality:
Paper tube:
• Be sure to set paper roll(s) prior to using your machine, otherwise it may cause a malfunction.
Install the paper roll in the printer. Be careful then to set the roll and cut the paper end correctly.
(How to set the paper roll)
To the printer
Incorrect
Paper replease lever
Receipt side

Installing the paper roll

Installing the receipt paper roll
118
44.5 ± 0.5 mm
52.3 — 64.0 g/m 2
bond paper
18 mm
To the printer
Correct
To release the paper, press the paper release lever down. It is
also used for removing a paper jam. The method for removing a
paper jam is described in "Removing a paper jam" later in this
section.
Journal side
1.
Turn the mode switch to the "REG" position with the AC cord
connected.
2.
Remove the printer cover.
3.
Set the paper roll correctly and drop it into the printer.
4.
Press the receipt paper release lever down and insert the
paper end into the paper chute of the printer.
5.
Pull the paper end that has come out of the printer, holding
down the lever.
6.
Advance the paper by a required length by pressing the receipt
paper feed key.
7.
Replace the printer cover.
(How to cut the paper end)
Correct Incorrect