Installing And Removing The Paper Roll; Recording Paper Specifications; Installing The Paper Roll - Sharp UP-700 Instruction Manual

Installing and Removing the Paper Roll

Recording paper specifications

Be sure to use paper rolls specified by SHARP.
The use of any other paper rolls than specified could cause paper jamming, resulting in a POS terminal
malfunction.
Paper specification
Paper width:
Max. outside diameter:
Quality:
Paper tube:
• Be sure to set paper roll(s) prior to using your machine, otherwise it may cause a malfunction.
Install the paper roll in the printer. Be careful to set the roll and cut the paper end correctly.
If the top end of the paper roll is fixed with paste or tape, the paper may lose its color
NOTE
development ability in the pasted or taped area due to the deterioration of the heat-sensitive
color development component of the paper surface. This may result in nothing appearing at this
location when printing is performed. Therefore, when setting a new paper roll in the machine, be
sure to cut off approximately one revolution (approx. 25 cm long).
(How to set the paper roll)
To the printer
Incorrect

Installing the paper roll

Installing the receipt paper roll
2.26 0.02 in. (57.5
3.15 in. (80 mm)
Thermal paper
0.71 in. (18 mm)
To the printer
Correct
1.
Turn the mode switch to the "REG" position with the AC
cord connected and the power switch "ON".
2.
Remove the printer cover.
3.
Check that the print head release lever is in its printing
position.
4.
Set the paper correctly as illustrated above in the
Printing
receipt side of the printer.
position
5.
Insert the end of the paper into the paper chute as
shown on the left. It will automatically be fed through the
printer.
6.
Cut off the excess paper that comes out of the printer
with the manual cutter.
7.
Replace the printer cover.
0.5 mm)
(How to cut the paper end)
Correct Incorrect
217