Digital Output; Downsampling; Source Direct - Denon DVD-2930 Operating Instructions Manual

ENGLISH
Making the initial settings

Digital output

Use this procedure to set the signal format of the digital audio output.
1
[D D H H ]
Use to select "DIGITAL OUTPUT", then press
[ENTER]
.
2
[D D H H ]
Use to select the item to be set, then press
[ENTER]
.
NORMAL (Upon purchase):
Select this when an AV amplifier with built-in Dolby Digital or DTS
decoder is connected to the DVD-2930's digital audio output
terminal.
When playing discs recorded in Dolby Digital or DTS, the
corresponding bitstream signals are output.
PCM:
When playing discs recorded in Dolby Digital or DTS, the signals are
converted to 48 kHz/16 bit PCM (2-channel) before being output.
1
2
• When playing discs recorded in linear PCM or packed PCM, the
signals are output in linear PCM format, regardless of this setting.

Downsampling

Use this procedure to set the digital audio output when playing DVDs
recorded in linear PCM or packed PCM.
1
[D D H H ]
Use to select "DOWN SAMPLING", then
[ENTER]
press .
2
[D D H H ]
Use to select the item to be set, then press
[ENTER]
.
OFF (Upon purchase):
For DVDs recorded in linear PCM or packed PCM without copyright
protection, 2-channel audio signals of up to 96 kHz are output as
linear PCM signals with no conversion. (192 kHz and 176.4 kHz
signals are converted to 96 kHz and 88.2 kHz, respectively.)
ON:
Linear PCM or packed PCM signals are converted to 48 kHz or less
for output.
Set to "ON" when using digital connections to an AV amplifier
that is not compatible with sampling frequencies of 192 kHz,
176.4 kHz, 96 kHz and 88.2 kHz.
1
2
• For DVDs containing multi-channel PCM signals, the signals are
down-mixed into the 2-channels and output in digital format. (For
sources for which down-mixing is prohibited, only the FL and FR
channels are output.)
• When playing linear PCM or packed PCM DVDs with copyright
protection, due to considerations for the copyright holder, digital
output is not possible for sources of 48 kHz/16 bit or more.
To play such sources, either set to "ON", use DENON LINK or
analog connections ( page 9, 10).
23
ENGLISH
Making the initial settings

Source direct

Use this procedure to making the setting for direct audio output of the
disc's data without making the "SPEAKER SETUP" settings at
"AUDIO CHANNEL".
Making this setting allows you to enjoy full-band playback of all
channels, as recommended for DTS. (Note that this setting increases
the volume of the subwoofer by 5 dB, or 15 dB for Super Audio CDs.)
This setting also lets you enjoy playback of 6-channel DVD-Audio
sources recorded in full frequency band for all channels.
1 [D D H H ]
Use to select "SOURCE DIRECT", then press
[ENTER]
.
2 [D D H H ]
Use to select the item to be set, then press
[ENTER]
.
OFF (Upon purchase):
Select this when playing using the "SPEAKER SETUP" and "BASS
ENHANCER" settings.
50kHz, 100kHz:
When playing Super Audio CDs, frequencies higher that these
respective frequencies are cut.
Set to "100kHz" when using an amplifier compatible with high
frequencies.
1
AUDIO SETUP AUDIO SETUP
2
AUDIO CHANNEL AUDIO CHANNEL
DIGITAL OUTPUT DIGITAL OUTPUT
DOWN SAMPLING DOWN SAMPLING
SOURCE DIRECT SOURCE DIRECT OFF
BASS ENHANCER BASS ENHANCER 50kHz
COMPRESSION 100kHz
EXIT:SETUP/RETURN
SELECT: SET:ENTER