Follow System Wide Event: Program Addresses (2740-2771) - Bosch DS7400Xi Reference Manual

10.36 Octal Relay Module Output Programming (continued)

10.36.2 Follow System Wide Event: Program Addresses (2740-2771)

To program an Octal Relay Module for Follow System Wide Event, follow the steps below.
1. Select Octal Relay to program.
2. Program Data Digit 1 of Program Address A as 2 for Follow System Wide Event.
3. Program Data Digit 2 of Program Address A for the desired function.
4. Program Data Digit 1 and 2 of Program Address B for the desired function.
Once both Address A and Address B have been programmed, proceed to program the next Octal Relay.
For Octal Relay Partition Assignment, see section 10.36.5.
Program Address A
Data Digit
1 2
2
SELECT OPTION DD 2
Follows 3
0 1 2
Disabled
Burglar Alarm
Fire Alarm
DS7400Xi ( 4+) Reference Guide
Octal DS7488-1 DS7488-1
Relay Address Address
# A B
1 2740 2741
2 2742 2743
3 2744 2745
4 2746 2747
5 2748 2749
6 2750 2751
7 2752 2753
8 2754 2755
9 2756 2757
10 2758 2759
11 2760 2761
12 2762 2763
13 2764 2765
14 2766 2767
15 2768 2769
16 2770 2771
Copyright © 2007 Bosch Security Systems, Inc.
Program Address B
Data Digit
1 2
SELECT OPTION DD 1 & 2
Disabled
AC Power Fail
Low Battery
Communicator Failure
System Fault*
Keypad Supervision Fault
Multiplex Bus Fault
RF Receiver Fault
Aux Power Fault
Fire Zone Trouble
Supervisory
Zone Trouble
Duress
Battery Test
Future Selection
Future Selection
*System Faults include:
• RAM fault
• ROM fault
• Bell/Line Monitor fault (DS7420i)
• Line 1 fault
• Line 2 fault
• Bell fault
• Aux. Power fault
• Octal Relay fault
• Serial Module fault (DS7412)
• Serial Transmit fault
• Serial Receive fault
• Aux. Relay fault
• DS7416i Communication fault
• RF Receiver Tamper
• RF Receiver Jammed
• RF Receiver Trouble
• Printer Off-line
P/N: F01U035325-01
DD
0 0
0 1
0 2
0 3
0 4
0 5
0 6
0 7
0 8
0 9
0*0
0*1
0*2
0*3
0*4
0*5
Page 61