Before Using The System; Setting The Navigation Mode; Setting The Language Mode - Alpine NVD-T334 Owner's Manual

Before Using The System

SOURCE/POWER
NAV.
MENU RTN

Setting the Navigation Mode

1
Press SOURCE/POWER button to turn on the power.
2
Press the NAV. button.
Changing the Audio mode to Navigation mode.
The current vehicle position is displayed.
Number of received satellite signals
3
Press c button to open the display and then insert the
SMART MAP PRO disc.
4
Move the Flipper switch up or down to move the
cursor to the desired language and press the OK
button or MODE knob to execute the selection. (When
the system is used for the first time)
Note
For English, you can select the distance indications in either
miles (mile) or Kilometres (km).
For other languages, only kilometres are used for the distance
indications.
10
-EN
OK MODE
Flipper switch
c
5
Selected language is displayed.
An important message is displayed. Please read this
message after stopping the vehicle in a safe location.
Press the OK button. (You cannot carry out this
operation with the Enter button on the optional remote
control.)
6
The present vehicle position is displayed.
Note
Some operations (when displaying the navigation menu, etc.)
cannot be performed while the vehicle is in motion. In this case,
be sure to first stop your vehicle and apply the parking brake,
then perform the operation.

Setting the Language Mode

For the picture/voice guidance and texts, you can
choose one of 8 languages as follows.
a German (Deutsch)
a English (mile or km)
a French (Français)
a Italian (Italiano)
The guidance language can be changed whenever you
like by following the procedure below.
1
Press the MENU button to display "NAV. MENU."
2
Select "Navigation Setup" from "NAV. MENU" by
moving the Flipper switch up or down and press the
OK button or MODE knob to execute the selection.
3
Select "System Setup" from "Navigation Setup" by
moving the Flipper switch up or down.
Press the OK button or MODE knob to execute the
selection.
4
Select "Language" from "System Setup" by moving the
Flipper switch up or down.
Press the OK button or MODE knob to execute the
selection.
a Dutch (Nederlands)
a Spanish (Español)
a Swedish (Svensk)
a Danish (Dansk)