Switching The Headphones On And Off - Sennheiser RS 125 Instructions For Use Manual

operation indicator
standby mode, its power consumption is very low so that it
can remain connected to the mains.
When not using the devices for extended periods of
time, pull out the mains connector from the wall socket.
In this case, however, the headphones' rechargeable
batteries will not be recharged.

Switching the headphones on and off

CAUTION! Hearing damage due to high volumes!
Listening at high volume levels for long periods
can lead to permanent hearing defects.
Switching the headphones on
Set the ON/OFF switch
to the position ON.
The headphones switch on and automatically start the
channel search on the last selected channel. If a channel is
found, the channel search stops. You hear the signal of the
found sound source.
If you do not hear the sound source after a short while, please
refer to the chapter "If a problem occurs ..." on page 18.
7
goes off. The transmitter is now in
Before putting the headphones on, set the
volume to a low level.
Do not continuously expose yourself to high
volumes.
4
on the headphones
Using the RS 125 system
/
13