Sennheiser RS 145 comfort Instruction Manual

Sennheiser wireless listening pleasure instruction manual
Hide thumbs Also See for RS 145 comfort:

Advertisement

Quick Links

Wireless Listening Pleasure
RS 145 comfort
Instruction mM a nual

Advertisement

Table of Contents
loading

Summary of Contents for Sennheiser RS 145 comfort

  • Page 1 Wireless Listening Pleasure RS 145 comfort Instruction mM a nual...
  • Page 3 BALANCE...
  • Page 4 ON/OFF CHARGE COMPRESSION INPUT LEVEL...
  • Page 5: Table Of Contents

    The RS 145 comfort RF headphone system ... 4 Delivery includes ... 4 Product overview ... 5 Putting the RS 145 comfort system into operation ... 7 Setting up the transmitter ... 7 Connecting the transmitter to a sound source ... 8 Connecting the transmitter to the mains ...
  • Page 6: Important Safety Instructions

    Important safety instructions Important safety instructions • Read this instruction manual. • Keep this instruction manual in a safe place. Always include this instruction manual when passing the system on to third parties. • Clean the devices and the mains unit only with a dry cloth. •...
  • Page 7 • a heat hazard, • a fire hazard, • a leakage hazard, • an explosion hazard, • a smoke or gas hazard. Please understand that Sennheiser does not accept liability for damage arising from abuse or misuse. Keep away from children. Observe correct polarity.
  • Page 8: The Rs 145 Comfort Rf Headphone System

    The RS 145 comfort RF headphone system The RS 145 comfort RF headphone system The RS 145 comfort RF stereo hi-fi headphone system offers excellent sound quality and allows for wireless listening everywhere in the house and garden. The lightweight headphones are extremely comfortable to wear and very easy to use.
  • Page 9: Product Overview

    Product overview An overview of the headphones and the transmitter is given on the inside front cover of this instruction manual. Overview of the headphones Headband Volume control TUNE button Balance control for volume adjustment Overview of the transmitter Charging cradle...
  • Page 10: Overview Of The Indicators And Acoustic Signals

    Volume of sound source is adjusted too high. Meaning 6 short beeps No signal! Transmitter is switched off or out of range. 2 long beeps Rechargeable batteries are almost flat. Sequence of Headphones have been 3 beeps switched off.
  • Page 11: Putting The Rs 145 Comfort System Into Operation

    One transmitter can be used to transmit to several headphones on the same frequency. Wall mounting the transmitter The transmitter is prepared for wall mounting. The required mounting hardware (screws and plugs) is not included in the delivery. Putting the RS 145 comfort system into operation...
  • Page 12: Connecting The Transmitter To A Sound Source

    Putting the RS 145 comfort system into operation Connecting the transmitter to a sound source You can connect the TR 145 transmitter to different sound sources, such as a TV, a DVD player or a stereo system. Switch your sound source off.
  • Page 13: Connecting The Transmitter To The Mains

    Pull the mains connector out of the wall socket. Inserting and changing the headphones’ rechargeable batteries Before using the RS 145 comfort for the first time, you have to insert the supplied rechargeable batteries. Lift the left earpad earpads” on page 18.
  • Page 14: Charging The Headphones' Rechargeable Batteries

    Putting the RS 145 comfort system into operation Charging the headphones’ rechargeable batteries Charge the rechargeable batteries for at least 16 hours prior to first time use. Subsequent charging time is about the same time as the previous operating time.
  • Page 15: Adjusting The Headband Of The Headphones

    Adjust the length of the headband so that – your ears are completely inside the earpads, – you feel even, gentle pressure around your ears, – a snug fit of the headband Putting the RS 145 comfort system into operation on the head is ensured.
  • Page 16: Using The Rs 145 Comfort System

    Using the RS 145 comfort system Using the RS 145 comfort system To switch the devices on and to listen to your sound source, proceed as follows: Sequence of steps 1. Make sure that the rechargeable batteries are charged. 2. Switch your sound source (e.g. TV) on.
  • Page 17: Switching The Headphones On And Off

    If you do not hear the sound source after a short while, please refer to the chapter “If a problem occurs ...” on page 19. Using the RS 145 comfort system goes off. The transmitter is now in continuously expose yourself to high...
  • Page 18: Searching For A Sound Source

    Using the RS 145 comfort system Switching the headphones off Set the ON/OFF switch to the position OFF. The headphones switch off. Always store the headphones on the charging cradle to ensure that they are fully charged when they are needed.
  • Page 19: Adjusting The Signal Of The Sound Source

    If the signal of the sound source is too strong, the indicator for speech intelligibility and sound signal Gradually reduce the volume of your sound source until the flashing stops. Using the RS 145 comfort system on the on the headphones. flashes slowly.
  • Page 20: Adjusting The Volume

    There is a click-stop in the center position. Enhancing the speech intelligibility The RS 145 comfort features a dynamic compression system which allows you to enhance the speech intelligibility. This system evens out volume differences, i.e. it reproduces soft passages louder and decreases loud sounds.
  • Page 21: Switching The Acoustic Signals (Beeps) On And Off

    The setting for the acoustic signals is retained in memory until you change the setting again or replace the rechargeable batteries. Using the RS 145 comfort system for 5 seconds.
  • Page 22: Cleaning The Rs 145 Comfort System

    Replacing the earpads For reasons of hygiene, you should replace the earpads from time to time. Spare earpads are available from your Sennheiser dealer (see “Accessories and spare parts” on page 21). To loosens the quarter turn fastener which secures the earpads to the earcups, turn...
  • Page 23: If A Problem Occurs

    Solution Choose a different place for the trans- mitter. Make sure that the transmitter is not placed close to metal objects. Move the headphones closer to the transmitter. If necessary, switch the headphones on again. Check the connection between the transmitter and your sound source.
  • Page 24 If a problem occurs that is not listed in the above tables or if the problem cannot be solved with the proposed solutions, please contact your Sennheiser partner for assistance. Solution Turn the balance control or right.
  • Page 25: Accessories And Spare Parts

    Accessories and spare parts Only use original Sennheiser accessories and spare parts, otherwise the device quality can be impaired or the devices can be damaged. Cat. No. Accessory/spare part 502821 1 HDR 145 additional headphones 511792 1 pair of earpads...
  • Page 26 Specifications TR 145 transmitter Weight Dimensions (incl. charging cradle) HDR 145 headphones Transducer principle Max. SPL (at 1 kHz) THD (at 1 kHz) Power supply Charging time Operating time Weight NT-RS 110 mains unit Nominal input voltage Mains frequency Nominal output voltage...
  • Page 27: Manufacturer Declarations

    Manufacturer Declarations Warranty Sennheiser GmbH & Co. KG gives a warranty of 24 months on this product. For the current warranty conditions, please visit our web site at www.sennheiser.com or contact your Sennheiser partner. CE Declaration of Conformity This equipment is in compliance with the essential requirements and other relevant provisions of Directives 2006/95/EG and 1999/05/EG.
  • Page 28: Index

    Adjusting the balance 16 Adjusting the volume 16 Automatic channel search 14 Charging the headphones 10 Cleaning 18 Operating elements of the headphones 5 Operating time 10 Replacing the earpads 18 Searching for a sound source 14 Switching the acoustic signals on/off 17...
  • Page 30 Printed in China Sennheiser electronic GmbH & Co. KG Am Labor 1, 30900 Wedemark, Germany Publ. 09/08 www.sennheiser.com 532002/A01...

Table of Contents