Replacing Batteries - Fluke 1625 User Manual

detergent or spirit. Avoid aggressive cleaning agents and solvents (trilene,
chlorothene etc.).
Service work must only be undertaken by trained qualified staff.
In all repair work care must be taken that the design parameters of the instru-
ment are not modified to the detriment of safety, that assembled parts corre-
spond to the original spares and that they are reassembled properly (factory
state).
Before any maintenance, repair or parts replacement the
instrument must be disconnected from all voltage sources.

Replacing Batteries

NiMH or NiCADcells may be used but must be charged outside of the
instrument. The number of measurements available with these cells
will typically be different to those available using alkaline cells.
This instrument is equipped with six 1.5 V batteries IEC RL 6 or type AA. If
after pressing the START-button all display-segments are lit (instrument re-
sets, display-test) or if "LO-BAT" appears on display during a measurement
the batteries must be replaced or the accumulators must be recharged.
For replacement of batteries the measuring cable must be
disconnected, and the instrument switched off. Now the
two screws at the rear of the instrument can be loosened
with a suitable tool (screwdriver) and the battery recess
cover removed. When replacing batteries, mind the correct
polarity.
Always replace the complete set of batteries.
For protection of the environment, please ensure proper disposal of
the batteries.
Caution
Note
Caution
Note
Earth/Ground Tester
Care and Maintenance
61