Getting Started; Display Indicators; Quick Start - iHome iW4 User Manual

Getting Started

Display Indicators

AM and PM Indicator
Mode and Status Display
Network Connected

Quick Start

1
Connect AC power
- Connect AC power adaptor, pull tab
from the backup battery compartment
on bottom of unit
outlet
sync
skip alarm
2 alarm 1 alarm nap presets eq
power
12V
status network setup
12V 3.5A aux-in
4
Play, charge, sleep & wake
- Dock your iPad, iPhone, or iPod and press
to enjoy your favorite music
- Press the Mode button to select AirPlay,
iPod, FM Radio, or AUX-in modes
- Press & hold Alarm 1 & 2 buttons to set your
desired wake preferences
power
eq presets nap alarm 1 alarm 2
English
Time Display
strong signal strength
medium signal strength
low signal strength
2
Power on your iW4
- Press the Power button to switch
between power ON and standby
- Press & hold the Power button (4 sec.)
to turn iW4's Wi-Fi network OFF/ON
Remove tab from bottom
of iW4 for battery backup
5
Connect to your Wi-Fi network
- Dock iOS 5.0 or later device (verify Wi-Fi is
ON and connected to desired network)
- Press Network Setup button on iW4
- Select 'Allow' on pop-up message
- Keep reading for additional setup methods
status
alarm skip
sync
FRONT DISPLAY
NETWORK STATUS
Network Not Connected
Network OFF
power
eq presets nap alarm 1 alarm 2
alarm skip
sync
network setup
sync
skip alarm
2 alarm 1 alarm nap presets eq
power
Connect
status network setup
12V 3.5A aux-in
Share Wi-Fi Settings?
Do you want to share your Wi-Fi
settings so this accessory can
connect to the Wi-Fi network?
Allow Ignore
Battery Low Indicator
Firmware Status Indicator
Alarm Indicators
Network Status Indicator
Active AirPlay Stream Indicator
iHome App Indicator
Not connected | OFF, iPod, Radio, or Aux mode
Not connected | AirPlay mode
iW4 Wi-Fi network OFF (Press & Hold Power button)
* AirPlay mode will be unavailable in Network OFF state
3
Set clock with AutoSync
iW4 will automatically sync time
with your docked iPad, iPhone or iPod
power
eq presets nap alarm 1
6
Enjoy AirPlay wireless audio
- Turn iW4 ON and select AirPlay mode
- Launch iTunes or use your iPad, iPhone,
iPad touch (verify network settings)
- Select the 'iHome iW4 XXXXXX' speaker as
your audio source (look for
Note: for AirPlay streaming: Note: for AirPlay streaming:
iPad, iPhone, and iPod touch support point-to-point
audio streaming to one AirPlay enabled speaker at a
time.
iTunes supports point-to-multipoint audio streaming to
up to three AirPlay enabled speakers (performance
depends on both your Wi-Fi network and environment).
alarm skip alarm skip
alarm 2
alarm skip
sync
AirPlay logo)
5