iHome iW4 User Manual page 16

Option D - Connecting directly via Ethernet
Follow this method if you have a wired home network or prefer the performance of a direct
connection with router.
Using an Ethernet cable (not provided):
1. Press & hold the Power button
2. Connect an ethernet cable to the iW4 rear
3. Press & hold the Power button
Success!
Congratulations, you have successfully connected your iW4 to your wireless network. Verify that the Network Status LED is green and that the
Network Status Indicator icon shows signal strength to confirm if the iW4 is successfully connected to a network. Keep reading on the other
side of this guide to start using AirPlay and other iW4 features.
Connected
sync
skip alarm
2 alarm
12V 3.5A
If the Network Status LED is green, the iW4 is
connected to a network
Visit our website for additional network setup instructions: www.ihomeaudio.com/support/airplay/
English
(4 seconds) to power OFF the iW4 network.
Ethernet Port and to your router (or network).
(4 seconds) a second time to power ON the iW4 network and establish a direct ethernet connection.
sync
skip alarm
2 alarm 1 alarm nap presets eq
power
status network setup
12V 3.5A aux-in
status network setup
1 alarm nap presets eq
power
status network setup
aux-in
If the Network Status LED is flashing red, the iW4 is not
connected to a network because, either:
- The iW4 has not been connected to a Wi-Fi network
- There is a problem with your Wi-Fi network
- Or, the iW4 is out of range
power
eq presets nap alarm 1 alarm 2
alarm skip
sync
Not Connected
status network setup
sync
skip alarm
alarm 2 1 alarm nap presets eq
power
status network setup
12V 3.5A aux-in
Network Problem?
power
eq presets nap alarm 1 alarm 2
alarm skip
sync
Reset the iW4 Network:
- Press & hold the Power button (4 sec.) to turn network OFF.
- Press & hold the Power button again to reactivate the network.
- Visit our website for additional instructions and support.
15