iHome iW4 User Manual page 13

Wi-Fi Network Setup for AirPlay
Check list
Please verify the following steps before attempting to connect your iW4 speaker to a Wi-Fi network:
To enjoy AirPlay wireless audio, you must have the following:
- iTunes or an iOS device (iPod touch, iPhone, or iPad).
- A functioning home network with Wi-Fi.
Download the latest software updates for iTunes and your iOS device to ensure that you are able to enjoy the latest AirPlay
enhancements and compatibility.
Download the iHome Set
Have your Wi-Fi network name (SSID) and password (if applicable) available for reference.
Note: AirPlay requires iTunes 10.1 (Mac and PC) or later; OR an iPad (3rd, 2nd, and 1st generations), iPhone 4S, iPhone 4, iPhone 3GS, iPod
touch (4th, 3rd, and 2nd generations) with iOS 4.2 or later. The iHome Set app requires iOS 4.0 or later.
Option A - Connection via Wi-Fi Sharing with iOS 5.0 (RECOMMENDED)
If you have an iPod touch, iPhone, or iPad with iOS 5.0 or later, we recommend that you use Wi-Fi network log-in sharing for the quickest
network setup experience.
Using an iOS 5.0 or later device:
1. Verify that the iW4 is powered on.
2. Activate Wi-Fi on your iPad, iPhone, or iPod touch (with iOS 5.0 or later) and connect to your preferred network.
3. Dock your iPad, iPhone or iPod touch with the iW4.
4. Press the Network Setup button
5. A pop-up message will appear on the iOS device asking if you want to share your Wi-Fi settings. Select
Your iOS device will share current wireless network credentials with the iW4 and a confirmation tone will sound. Verify that the Network Status
LED is green and then keep reading to learn how to use iW4 to stream your iTunes and iOS audio content using AirPlay.
power
eq presets nap alarm 1 alarm 2
alarm skip
sync
Connect
Connected
sync
skip alarm
2 alarm 1 alarm nap
12V 3.5A
aux-in
If the Network Status LED is green, the iW4 is
connected to a network
English
app for iPod touch, iPhone and iPad.
on the back of the iW4.
status
status network setup
presets eq
power
status network setup
If the Network Status LED is flashing red, the iW4 is not
connected to a network because, either:
- The iW4 has not been connected to a Wi-Fi network
- There is a problem with your Wi-Fi network
- Or, the iW4 is out of range
network setup
sync
skip alarm
2 alarm 1 alarm nap presets eq
power
status network setup
12V 3.5A
aux-in
Not Connected
status network setup
sync
skip alarm
2 alarm 1 alarm nap presets eq
power
status network setup
12V 3.5A
aux-in
'Allow' .
10:09 PM
Connect
Share Wi-Fi Settings?
Do you want to share your Wi-Fi
settings so this accessory can
connect to the Wi-Fi network?
Allow Ignore
Network Problem?
power
eq presets nap alarm 1 alarm 2
alarm skip
sync
Reset the iW4 Network:
- Press & hold the Power button (4 sec.) to turn network OFF.
- Press & hold the Power button again to reactivate the network.
- Visit our website for additional instructions and support.
12