Locations And Names Of The Controls - Pyle PL75DL Instruction Manual

7" single-din in-dash motorized touch screen lcd monitor w/ dvd/cd/mp3/mp4/usb/sd/ am-fm radio
Table of Contents

Advertisement

6. Trouble Shooting
Please read the user manual carefully before using the this player. If you have any troubles
in using this player, try to solve the problems by the suggestions mentioned below. If you can
not remove the trouble after using all the s ugges tions, please contact the company or the
technical service centre authorized by us. For the sake of your safety, please do not open the
cover and repair the player by yours elf, if that, it may cause electric shock.
NO PICTURE, SOUND AND INDICATION
* Ensure that the power cord is not damaged or the fuse is not blown.
NO SOUND BUT HAVE PICTURE
* Ensure that the player's audio output has a good connection .
* Check whether you have turned down the volume.
* Ensure that you have set the right AUDIO setup of the play er.
* Ensure that the audio is not under mute.
NO PICTURE BUT HAVE SOUND
* Ensure that the player's video output has a good connection with monitor's video input.
* Check whether the video connect or is damaged.
* Ensure that you have set the right VIDEO settings of the pl ayer.
FLAWS OF PICTURE OR SOUND
* Check whether the setting of AUDIO is right.
REMOTE CONTROL IS INSENSITIVE OR DOES NOT WORK
* Check the batteries of remote control and make sure that they are to be powerful and
good conductivity.
* Direct the remote control to the IR sensor of the player.
* Check whether there are some obstacles between the remote control and IR sensor.
SOME FUNCTION BUTTONS DO NOT WORK
* Turn off the power, then turn on again.
* Reset the unit to zero, then turn on again.
* Remove the front panel from the unit, then install it again and then turn on again.
THE RADIO DOES NOT WORK
* Check whether the antenna cable is connected firmly. Or manually tune for a station.
THE TFT DISPLAY LOST TOUCH EFFECT
*
In any mode, press the MENU on the remote to turn to the main interface, then press SET on the
remote t o turn to sett ing mode then press right arrow to select calibrate mode and then tap the
cross cursor as it show.
PDF created with FinePrint pdfFactory trial version
http://www.pdffactory.com

1.4 Locations and Names of the Controls

1
4
5
The figure of the front panel
SD
The figure of the Unit Chassis Facet After removing the Front Panel
1. POWER/MUTE BU TTON
2. MONITOR
3. USB JACK
4. REL BUTTON
5. VOL K NOB
6. >>I BUTTON
7. PLAY/PAUSE BUTTON
2
3
AV-IN
MOD
8
6
7
9
10
11
RESET
12
13
8
. MODE
B UTTON
9. I<< BUTTON
10. SEL BUTTON
11. AV IN JACK
12. CARD SLOT
13. RESET BUTTON

Advertisement

Table of Contents
loading

Table of Contents