Radio Operation - Pyle PL75DL Instruction Manual

3. Radio Operation

1. BAND BUTTON
In RADIO mode, press the BAND button on the remote
control or on the front panel to select your desired radio
band of FM1, FM2, FM3, AM1 and AM2, and the selected
band will be displayed on the small monitor of the front panel.
2. TUNE/SEEK UP/DOWN BUTTONS
In RADIO mode:
1) Press and hold the UP/DN button to automatically search
up/down for a available station from the current frequency.
2) Briefly press the UP/DN button to manually search up or
down with step by step for your desired station from the
current frequency.
3. APS BUTTON
In RADIO mode:
1) When pressing and holding the APS button, the radio
searches from the lowest frequency and checks the signal
strength level until 1 cycle search is finished. And then the 6 strongest stations are preset to the
corresponding preset number memory bank. The AS operation is implemented in each bank of
the selected band. When the AS operation is finished, the radio executes the preset scan, and
after preset scanning for one cycle, it will stop scanning and broadcasting the No.1 station for
FM1.(It can store 3x6 stations for FM and 2x6 stations for AM in all)
2) When briefly pressing the APS button on the front panel or the remote control, the radio searches
for each preset station from the M1. When the field strength level is more than the threshold level
of the stop level, the radio holds at that preset number for few seconds with releasing mute, and
then searches again. After finishing a circle of searching, it will stop searching on the M1.
NOTE: In FM band, FM1,FM2,FM3 is checked one at a time.
In AM band, AM1, AM2 is checked one at a time.
4. PRESET STATION [ 1-6 ] BUTTONS
1) To memorize the current frequency on the current band, press and hold any one of the six
Number buttons (1-6) .
2) To recall the memory station on the current band, press one of the Number buttons [1-6] .
5. STEREO/MONO BUTTON
Press the ST button on the remote control to select the STEREO or MONO sound mode for
FM band.
6. LOC BUTTON
1) When the signal of the distance radio station are very weak and the receiving effect is bad during
tuning, check whether there is the word LOC on LCD. If there is the word LOC on LCD, press this
button to turn off the LOC function, then tune again for the distance radio station;
2) When the signals from the local radio stations are too strong, this could lead to interference.
press this button to turn on the LOC function, and the LOC icon will be lit up on the LCD.
Re-tune for the local station required.
PDF created with FinePrint pdfFactory trial version
RADIO interface
RADIO interface
http://www.pdffactory.com
After enlarging or minifying videos or image, press one of the ^/v/>/<
buttons to select the area you want to view.
In MP3/WMA mode, the ZOOM button is invalid.
4.12 Change Caption Language
In MP4 mode, during playback, press the SUBTITLE button repeatedly
to select the language of the caption or turn off the caption.(depend on
the file played)
In JPEG/MP3/WMA mode, the SUBTITLE button is invalid.
4.13 Look over Playback Information
1. In MP4/MP3/WMA mode, press the OSD button repeatedly to turn on/off
the playback information. When it is on, it will display the information such
as: Track serial number, Track elapsed time, Track remained time, etc.
2. In JPEG mode, press the OSD button to display or disappear the Track serial
number.
4.14 Program Playback
It allows you to enter the order in which you want some chapters/tracks in
MP3/WMA mode to play.
1 During playback, press the PROG button to enter a program interface as
follows:
2 Use the direction buttons to move cursor onto the desired place for inputting
the sequence number.