Related Manuals for Pyle PLMRB29B
Summary of Contents for Pyle PLMRB29B
- Page 1 In-Dash AM/FM Receiver with MP3 Playback & USB/SD/AUX Inputs PLMRB29B USER’S MANUAL - 0 -...
-
Page 2: Table Of Contents
COTENTS COTENTS ....................................1 PRECAUTIONS ..................................2 Precautions & Warnings ..............................2 Lithium Battery Cell Warnings ............................2 Drives and connections ..............................2 Others Warnings ................................2 INSTALLATION ..................................3 Installation Procedures ..............................3 Installation Opening ................................ 3 To Install the Car Radio ..............................3 Wiring Connections ................................. -
Page 3: Precautions
PRECAUTIONS Precautions & Warnings • To reduce the risk of fire, electric shock, and interference, do not attempt to repair this unit yourself. Refer all service to a qualified technician. • Some MP3/WMA files may not be playable. • Keep the volume at a reasonable level to avoid distracted driving. High volume levels may make it difficult to concentrate on traffic and road conditions while driving. -
Page 4: Installation
INSTALLATION Installation Procedures First complete the electrical connections and then check for correctness. Installation Opening This unit can be installed in any dashboard Having an opening as shown the right figure. 53 mm 182 mm To Install the Car Radio Be sure you test all connections first, and then follow these steps to install this unit. -
Page 5: Wiring Connections
INSTALLATION DASH BOARD DIAGRAM DIAGRAM HEX NUT DIAGRA HEX NUT DIAGRA SPRING WASHER CONSOLE DIAGRAM DIAGRAM PLAIN WASHER DIAGRAM MOUNTING SLEEVE TAPPING SCREW DIAGRAM DIAGRAM HEX BOLT DIAGRAM - Only use speakers with 4 ohms impedance. - Do not attach the control panel to the chassis before wiring is complete. - The maximum current of the auto antenna is 200mA. -
Page 6: Control Panel Button Loactions
CONTROL PANEL BUTTON LOACTIONS PLM RB29W (power)/MODE (source) button 2. SEL (select/menu) button and VOL (volume) knob 3. BAND(band) button, button 4. AMS (automatic store / preset station scan, automatic music search) button (pause/play), Preset station 1 button 6. INT (intro), Preset station 2 button 7. -
Page 7: General Operation
GENERAL OPERATION Turn Unit On/Off • Press the power ( ) /MODE button on the front panel to turn on the unit, and long press it again to turn off the unit. • Press the power ( ) button on the remote control to turn the unit on or off. Adjust Volume (VOL) Rotate the VOL knob on the front panel or press the VOL+ /VOL-... -
Page 8: Change The Source (Mode)
3. Press the button on the front panel or on the remote control to adjust the hour. 4. Press the CLK button and the minutes will flash. 5. Press the button on the front panel or on the remote control to adjust the minute. 6. -
Page 9: Radio Operation
RADIO OPERATION Switch Between USA area and Europe area Frequency In radio mode, press and hold the VOL/SEL button to enter switch state of the EU(USA) and EU (europe) frequency, then rotate it to switch between US(USA) and EU(europe) frequency. The system will change the frequency setting in about 3 seconds. -
Page 10: Usb / Sd Card Operation
USB / SD CARD OPERATION To insert USB / SD CARD • To play files on a USB device, open the USB port cover and insert the USB storage device into the USB port. Playback will begin automatically. • Insert the SD card into the SD slot on the chassis. Playback will begin automatically. Eject USB/SD •... -
Page 11: Select The Track Or File For Playback In Mp3 Format
So you can listen to sounds and music from external devices, if you have plugged such a player into the AUX IN jack with a audio cable. Press the MODE button to switch to the AUX input mode on or off. PLMRB29B - 10 -... -
Page 12: Bluetooth Operation
To begin pairing, enable BT mode on your mobile phone. 2. When the phone the car audio system, the “PYLE” name will be displayed. 3. Choose “PYLE” from the device list to pair and connect with the car audio system. Upon confirming, the BT logo will stop flashing. -
Page 13: Remote Control
REMOTE CONTROL Remove Insulating Sheet The remote control comes with an insulating sheet attached to the underside of the remote control, as illustrated on the right. The remote control will not work until the insulating sheet is removed. Replace Lithium Battery Cell 1. -
Page 14: Specifications
SPECIFICATIONS General Chassis Dimensions...............178(W) x 160(D) x 50(H) mm Power Supply Requirement ...................DC 12V Current Consumption ..................10A (max.) Maximum Power Output ..................4 x 75W Radio USA/ Europe Frequency Range........87.5 - 107.9 MHz (200KHz/Step) 87.5 - 108.0 MHz(50KHz/Step) Usable Sensitivity ....................30 dBu I.F. -
Page 15: Troubleshooting
TROUBLESHOOTING If you suspect something is wrong, immediately switch power off. Do not use the unit in abnormal condition, for example without sound, or with smoke or foul smell, can cause fire or electric shock. Immediately stop using it and call the store where you purchased it. Never try to repair the unit by yourself because it is dangerous to do so.