Description Of The Rear Cabinet - Pyle PL75DL Instruction Manual

1.5 Wires Connection Description
The Description of the Wires Connection
Fixing Screw Bolt
PARKING LINE
Wiring Connecting Socket 2 BROWN
PINK
Black
REVERSAL LINE
Note: 1. Use the clip end of a Ground Line provided by manufacturer to connect the Fixing Screw Bolt, use another end of t he Ground
Line to connect the negative pole of the power source. Otherwise, the video on screen maybe flashes.
2. When turning on rear view camera, sound of the current function mode will be muted.
The Description of the Wires Connection of the Wiring Connecting Socket 1
YELLOW
MEMORY B+
10 A FUSES
BLACK(GND)
RED
IGNITION SWITCH
0.5 A FUSES
BLUE AUTO ANT
FRONT WHITE
WHITE / BLACK
LEFT
SP
GREEN
REAR
GREEN / BLACK
NOTES:
1. Only speakers with 4 ohms impedance may be used.
2. Ensure that the blue auto antenna cable does not make contact
with any ground connection.
The Description of the Wires Connection of the Wiring Connecting Socket 2
RED R
BROWN
WHITE L
AUX IN
YELLOW VIDEO
YELLOW
GREY
VIDEO OUT LINES
YELLOW
BLACK
YELLOW
REAR VIEW CAMERA
NOTES: The rear AUX IN and the front AUX IN can not be used at the same time.
Description of Connecting the Parking Brake Line to the Parking Brake System Built in the Car
Parking brake
Parking brake switch
(inside the car)
NOTE: after connecting the Parking Line, the video on the small monitor of the front panel will be display only after braking the car.
PDF created with FinePrint pdfFactory trial version
Wiring Connecting Socket 1
Radio Antenna jack Black
WIRING CONNECTING SOCKET 1
WIRING CONNECTING PLUG 1
SUBWOOFER LINE OUT
YELLOW
RED R
RCA LINE OUT
WHITE L
GRAY
FRONT
GRAY / BLACK
RIGHT
SP
VIOLET
REAR
VIOLET / BLACK
WIRING CONNECTING SOCKET 2
WIRING CONNECTING PLUG 2
Ground(-)/Park Break(Green)
To metallic body or chassis of the car
http://www.pdffactory.com
4.16.5 SPEAKER SETUP
DOWNMIX
It is for selecting your desired sound effect when there is no center speaker
and subwoofer. There are 3 modes: LT/RT, STEREO, VSS.
LT/RT: When playing a media with PRO LOGIC Dolby
item, so it will output audio signal with vivid theatre effect.
STEREO: If you choose the item, when outputting audio signal with 5.1 channels,
it will output the left and right channels of signal ; when outputting audio signal
with 2 channels, it will output the common 2 channels of stereo signal.
VSS: If you choose the item, when playing a media recorded with 5.1 channels,
the main channel speakers can output audio signal with VSS effect.
4.16.6 DIGITAL SETUP
OP MODE
It is for selecting audio output mode
DYNAMIC RANGE
After selecting the compression mode of LINE OUT, set the item, so you can
adjust the linear compression ratio. If you set it to be FULL, the Peak-to-Peak
value of the audio signal is the minimum; if you set it to be OFF, the Peak-to-
Peak value is the maximum.
DUAL MONO
It is for selecting a desired audio output mode for the left and right ways of signal.
It is mainly for Karaoke of Ac3. There are 4 modes in all as follows:
STEREO, MONO L, MONO R, MIX MONO.
stereo effect, choose the